Sold with thread-locking adhesive to prevent them from loosening.
Easy to assemble/disassemble
Phillips screwdriver, ideally PZ3 or PH3.
Compatibility with bindings
Important: these screws are suitable for a large majority of bindings, but it is imperative to check that the disc of your binding is not too thin.
To do this, remove your binding and take the central disc, place 1 screw and 1 washer in one of the housings. Measure the length of screw protruding from the disc.
If this length is greater than 6 mm after tightening, you will deform the base of your snowboard in front of each screw. Do not mount these screws on this binding.