Capacity

Stability

Corrosion resistance

Easy assembly/dismantling

Important:These screws are suitable for most bindings, but you must check that the disc on your binding is not too thin or too thick.
To do this, remove your binding and take the central disc, then place one screw and one washer in one of the housings. Measure the length of screw protruding from the disc. 

If this length is greater than 6 mm (0.24”) after tightening, you will deform the base of your snowboard in front of each screw. Do not use these screws on this binding.

Compatibility with bindings

The screws will be too long, forcing and distorting the base.

Risk if your binding disc is too thin for these screws

The screws will be too short. At best, you won’t be able to screw them in, but the worst scenario is that you can only screw in one or two threads. 
This can be dangerous, as the screw will have a lower resistance and a binding could rip out while you are riding.

Sports/

Winter Sports/

Snowboarding Gear/

Snowboard Accessories/

dreamscape

Snowboard Binding 16 mm Screws and Washers x 8